Melting in the Screw From left to right during processing, melting takes places. The material...


Melt Extrusion Process

12 Extrusion Defects and Troubleshooting
Interrupted Melt Output: Unbalanced barrel temperatures Surging: Due to contaminated material, wrong temperature settings, or...

What is Extrusion? Plastic Extrusion Process
Typical Thermoplastic Extruder The selection of the extruder barrel diameter depends on the dimensions of...

11 Injection Molding Defects and Troubleshooting
Short Shot Flash Sink Marks Splay Marks If the material is used without predrying, the...

Vent, Screw and Cooling Designs – Injection Molding
Injection Molding Vent Design Why Back Pressure is Important in Injection Molding Back pressure is...

Moving the Material – Injection Molding
Material Moving In The Runner As shown above, the best selection on the runner is...

What is Injection Molding?
An injection molding press consists of two halves, a clamping side and an injection side....

Meet Your TPE Solution Partner at K Show 2025
TPE SOLUTIONS THAT CONTRIBUTE TO PEOPLE’S DAILY LIVES! Elastron provides TPE solutions to its global...

Water Footprint Training Successfully Completed
Water Footprint Training Successfully Completed The Water Footprint Training, an essential step within the framework...

Elastron partners with plastic distributor Chase Plastics!
Elastron partners with plastic distributor Chase Plastics Elastron and Chase Plastics announced today the formation...

Plast Eurasia 2024’de Bize Katılın!
Elastron olarak, uluslararası plastik endüstrisinin önde gelen fuarlarından biri olan Plast Eurasia 2024’te yer alacağımızı...

Meet your TPE solution partner at Fakuma 2024
Join us at Fakuma Fair, October 15 to 19 in Friedrichshafen! Fakuma is a world-renowned...

Meet your TPE solution partner at NPE 2024 Plastics Show
Join Elastron at NPE 2024 and witness our unwavering commitment to being Your Proactive and...